Shokaku class (elevator) deck section 1/72

As shown in the picture this deck section represent 
mid or aft elevator on shokaku class carrier

It can be used for Shokaku or Zuikaku

Dimensions of the real elevator are 12 m x 13 m

For now it is only aviable in 1/72 scale
Dimensions 230 x 200 mm

Material is baltic birch plywood 4 milimeter thick
Also it can be made from 3mm HDF or
Thin plastic sheet (similiar to styrene 1.5mm thick) - last photo

If you like scratchbuilding, elevator section can be cutout

 Biplane holder (BPH_01)

Extension for AH_01 and AH_03_max

It is made for easier rigging and working on biplanes

It can be adjusted by angle and distance

Material of the extension is 3mm plywood 
(optionaly can be HDF 3mm thick)

This jig extension holds perfectly scale model 
when you are working on it

Teeths on lower surface are made for ruber band, 
so you can use it also for transporting your biplane

 Rotation paint table (RPT_01)

Rotation jig made for painting 
Diameter of the jig is 220 mm
Material is 3mm thick HDF (high density fiberboard)

Jig has integrated bearings for easier rotation

Holes on upper surface are made for bamboo sticks

for easier painting small parts.

On lower surface jig has four antislip rubber buttons

 Aircraft holder (AH01)

Suitable for aircraft made from 1/144 up to 1/48 scale

Max distance between columns is 200 mm

Max diference in column height is 30 mm

Contact surfaces with the scale model are made

from eva foam to prevent any scratches

Columns have engraved teets so you can put 

elastic band to hold airplane in place

On the photos is the old version of the jig, made from plywood. 

New version is made from HDF (high density fiberboard)